- Add sparkle to most surfaces with the Hot-Fix Heater.
- The heated tip activates the hot-melt adhesive on the back of the hot-fix flat back crystals, allowing you to position crystals exactly where you want them, then apply the heater to the front of the crystal.
- In seconds, you'll transform the ordinary into the extraordinary.
- Hot fix applicator with eight interchangeable screw-on tips.
- Designed to work with specific hot-fix crystal sizes, the twist on brass tips make it easy to precisely place hot-fix crystal rhinestones with consistent heat.
- Flat spot tip works great with iron-on embellishments.
- Tips are engraved with mm and SS crystal sizes for convenience.
- Includes mini-stand to protect work surface while designing.
Interchangeable tips for hot-fix crystal sizes:
· 2mm (SS6)
· 2.5mm (SS8 - SS9)
· 3mm (SS10)
· 4mm (SS16)
· 5mm (SS10)
· 6mm (SS30)
· 7mm (SS34)
· 5mm flat spot (for use with iron-on transfers) -
Instructions:
-
Place a hot-fix crystal in position on your project (glue side facing down).
-
Slide applicator to the ''ON'' position. Press red button and hold down to activate the heating element. Wait approximately 30 seconds. Caution: Do not touch any metal parts. The applicator will get very hot.
-
Holding the applicator vertically, continue to hold the red button down and lightly touch the top of the crystal. You do not need to use any pressure -- just a gentle touch for about three seconds. The heat will radiate through the crystal and activate the glue on the hot-fix crystal. The embellishment will now be securely attached.
-
Remove the applicator. Release the red button to allow applicator to cool. When you have completed your project, slide the black switch to the ''OFF'' position. This is a safety feature to prevent the applicator from heating even if the red button is held down.
Note: To avoid burning your project, be especially careful when adhering crystals smaller than the head of the applicator.
Not recommended for leather, water resistant material or non-porous surfaces.
Before beginning any project, always test the hot-fix crystal in an inconspicuous area to make sure you are getting the best adhesion possible.
Tip: Hand-wash fabrics with embellishments.Specifications:
· UL/CUL listed
· 120 volt
· 6.5 watts
· 64-inch power cord
-
Hot Fix Crystals available in our store.
- *Please consider the actual sizes given in the listing as the pictures are generally enlarged to show detail.