Drawplate Set, 2 Piece BeadSmith Plastic Wire Chain Draw Plate Set Holes 1.5 to 14.5mm

Drawplate Set, 2 Piece BeadSmith Plastic Wire Chain Draw Plate Set Holes 1.5 to 14.5mm

BeadSmith

$21.97
Write a Review
Condition:
New
Shipping:
Calculated at Checkout
Adding to cart… The item has been added
  • You use this to condense the diameter of wire chain without scratching or marring the surface of the wire.
  • To use you simply place the beginning end of the wire chain with the start wire into the hole that most clearly matches the current diameter of the chain.
  • Holding the drawplate in one hand, grasp the start wire with pliers and pull the chain through as many times as necessary to make the chain smooth and round.
  • If you want to make smaller chain then simply repeat the same steps but gradually moving down the holes sizes.
  • The drawplate can also be used for straightening single strands of wire and for hardening wire before use.
  • A simple way to make wire based chain round & smooth and to condense the diameter of the chain without scratching or marring the wire.
  • Includes complete directions for using the plate and can be used with any soft wire.
  • 23 holes range in diameter from approximately 1.5 to 14.5mm..
  • *Please consider the actual sizes given in the listing as the pictures are generally enlarged to show detail.
!